Hey Guys,
Do any of you run a voltage stabilizer / regulator on your plasma cutter. I might be having an issue with this interfering with my THC. Table is grounded. If you do did it help?
Thanks,
Mike
Voltage Regulator Stabilizer
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2318
- Joined: Fri Apr 17, 2009 11:48 am
Re: Voltage Regulator Stabilizer
Hey Mike, that shouldn't be needed. Are you having a problem that you are trying to solve by installing this?
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 11188
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Voltage Regulator Stabilizer
What are the symptoms of your interference problem? It would probably help if you would describe in detail of your complete setup - plasma cutter, table, controller, software, etc. Photos might also be nice.topkote wrote: Mon Oct 04, 2021 8:11 am Hey Guys,
Do any of you run a voltage stabilizer / regulator on your plasma cutter. I might be having an issue with this interfering with my THC. Table is grounded. If you do did it help?
Thanks,
Mike
David
