Voltage Regulator Stabilizer

General software related questions should be posted here.
Post Reply
topkote
2 Star Member
2 Star Member
Posts: 58
Joined: Mon Dec 07, 2009 10:42 am

Voltage Regulator Stabilizer

Post by topkote »

Hey Guys,

Do any of you run a voltage stabilizer / regulator on your plasma cutter. I might be having an issue with this interfering with my THC. Table is grounded. If you do did it help?

Thanks,

Mike
Top
weldguy
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 2187
Joined: Fri Apr 17, 2009 11:48 am

Re: Voltage Regulator Stabilizer

Post by weldguy »

Hey Mike, that shouldn't be needed. Are you having a problem that you are trying to solve by installing this?
Top
adbuch
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 10138
Joined: Thu Sep 21, 2017 5:22 pm
Location: Tucson, Arizona
Contact:
Contact adbuch

Re: Voltage Regulator Stabilizer

Post by adbuch »

topkote wrote: ↑Mon Oct 04, 2021 8:11 am Hey Guys,

Do any of you run a voltage stabilizer / regulator on your plasma cutter. I might be having an issue with this interfering with my THC. Table is grounded. If you do did it help?

Thanks,

Mike
What are the symptoms of your interference problem? It would probably help if you would describe in detail of your complete setup - plasma cutter, table, controller, software, etc. Photos might also be nice.
David
Top
Post Reply

Return to “General Discussion”