Modified Tube Roller

[adbuch]

I know this is an old thread, but does anyone have the updated dxf for this roller? Been wanting to make one for a while.

I was not aware that there was an updated dxf for this project. Have you checked out the dxf files previously posted? If you need something different, I think you could probably modify the design and the file accordingly. Did you have some specific changes in mind?

David

[Paul9207]

I thought that I read there were some tweaks to make to the dxf in one of the earlier posts is why I asked. I'm slowly getting the hang of navigating the forum.

[adbuch]

I thought that I read there were some tweaks to make to the dxf in one of the earlier posts is why I asked. I'm slowly getting the hang of navigating the forum.

[Fubar62172]

following

[tnbndr]

Not sure if this is Oldsarge file or not but I found it in my file storage. It is updated as far as the roller carrier slots instead of holes.

BENDER PIPE.dxf

[adbuch]

Tnbndr - thanks for sharing your file.
David

tube roller parts.jpg