Incomplete cuts

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
alanmccabe
1 Star Member
1 Star Member
Posts: 22
Joined: Sun Jul 18, 2021 10:46 am

Re: Incomplete cuts

Post by alanmccabe »

I did think about that control THC setting I assumed it was to permanently have the THC switched on regardless on the thc on switch on the run screen. In my case I want the THC off but UCCNC respect the arc ok light.
Home built 4x4 Plasma Cutter
UCCNC
Oxford 350 Plasma Cutter with machine port.
Trafimet Autocut S65P machine torch

co2 1200x600 75 watt laser
Co2 1300x900 100 watt laser
ruralfencer
2.5 Star Member
2.5 Star Member
Posts: 121
Joined: Mon Aug 16, 2021 5:12 am

Re: Incomplete cuts

Post by ruralfencer »

Finally got it cut, been busy with my normal part of my business
Attachments
20211117_150918.jpg
Mick
Owner/ operator
MJT rural Contracting
Weldclass t1200
Hypertherm Pwermax 45XP
adbuch
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 10067
Joined: Thu Sep 21, 2017 5:22 pm
Location: Tucson, Arizona
Contact:

Re: Incomplete cuts

Post by adbuch »

Nice job Mick! Since you don't have Design Edge to use for linking, you could also buy a copy of LightBurn for $60. You can get a 30 free trial to try it out. If you import your dxf into LightBurn and then export as dxf, it will automatically link your file the same way Design Edge does.
David

https://lightburnsoftware.com/pages/tri ... re-you-buy
LightBurn Trial.jpg
ruralfencer
2.5 Star Member
2.5 Star Member
Posts: 121
Joined: Mon Aug 16, 2021 5:12 am

Re: Incomplete cuts

Post by ruralfencer »

Thanks David I'll have a look at it
Mick
Owner/ operator
MJT rural Contracting
Weldclass t1200
Hypertherm Pwermax 45XP
Post Reply

Return to “Plasma Cut Quality Forum”