Corel closes open paths when saving as dxf
-
Sampson Jones
- 3 Star Elite Contributing Member
- Posts: 332
- Joined: Mon Jul 25, 2011 9:30 pm
Corel closes open paths when saving as dxf
Long time corel usesr . Weirdness happening now , when I do a save as crd drawing to dxf , when I open the new dxf open paths are closed . When I save as a cdr drawing that was grouped to dxf , when I open that the open paths are missing ? WTF ?
My design , 4ft x 8 ft water table
CandCNC electronics
Hypertherm powermax 65
Command Lineux
Super z 2
Sheetcam
Inkscape and corel draw
CandCNC electronics
Hypertherm powermax 65
Command Lineux
Super z 2
Sheetcam
Inkscape and corel draw
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2187
- Joined: Fri Apr 17, 2009 11:48 am
Re: Corel closes open paths when saving as dxf
That is very strange and I am not sure what that would start happening.
You can try restoring the default Corel setting that came when your software was new.
To do this press F8 and while holding it down open CorelDraw and defaults will be restored.
Curious if that works for you in this situation.
You can try restoring the default Corel setting that came when your software was new.
To do this press F8 and while holding it down open CorelDraw and defaults will be restored.
Curious if that works for you in this situation.
