consumables

Cut quality issues can be discussed here, most common issues have been discussed here and should help you.
Post Reply
Welder Kenny
2 Star Member
2 Star Member
Posts: 76
Joined: Wed May 15, 2019 8:12 am

consumables

Post by Welder Kenny »

Hey Guys you all are great at helping me out so I want to thank everyone now, Thank you all for all the info you provide me. Now my question, do these consumables look worn out?? my THC started going crazy like raising way up and not coming down I put new consumables in and Back to Normal cutting.. here is a sample of my project. Thanks again guys.
IMG_20200408_110422749.jpg
IMG_20200408_110422749.jpg (85.14 KiB) Viewed 512 times
IMG_20200408_110422749.jpg
IMG_20200408_110422749.jpg (85.14 KiB) Viewed 512 times
IMG_20200411_173622327.jpg
IMG_20200411_173622327.jpg (46 KiB) Viewed 512 times
IMG_20200411_173622327.jpg
IMG_20200411_173622327.jpg (46 KiB) Viewed 512 times
IMG_20200411_173632385.jpg
weldguy
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 2187
Joined: Fri Apr 17, 2009 11:48 am

Re: consumables

Post by weldguy »

Those look like they should be replaced soon but certainly not completely worn out yet. I am guessing something else is the problem but at least its working.
Welder Kenny
2 Star Member
2 Star Member
Posts: 76
Joined: Wed May 15, 2019 8:12 am

Re: consumables

Post by Welder Kenny »

well on a positive note I changed consumables and have almost cut a 48"x 96" sheet of A.R. 500 into small targets with the same Set of consumables, tweeked my speed just a little and keep my thc voltage around 97 or 98 before I was blowing through them like candy..
Post Reply

Return to “Plasma Cut Quality Forum”