Z axis - Stop on G31

[Plasron]

What settings in Sheetcam would cause Mach3 to stop on line 120 G31 Z-100 F19.685
On another file it stops on line 110 G00.4000
Please help
Ron

[acourtjester]

Ok a G31 command is looking for a Probe input signal, you did not state if the Z moved down until a safety was hit?
G0 is a move command but that line has not locations for it to go, there should be an axis name like X, Y, or Z .400

[Plasron]

Ok a G31 command is looking for a Probe input signal, you did not state if the Z moved down until a safety was hit?
G0 is a move command but that line has not locations for it to go, there should be an axis name like X, Y, or Z .400

Thanks acourtjester
Dropped the laptop we were using on the CNC machine and we are having to start from scratch on a new laptop.
I playing around with Sangit a video recording program so I can show you guys how I am doing processing etc.
hope this works
https://www.screencast.com/t/ns3UwO7X

[Plasron]

mach3 processed
https://www.screencast.com/t/POOC9K7h

[Plasron]

What settings in Sheetcam would cause Mach3 to stop on line 120 G31 Z-100 F19.685
On another file it stops on line 110 G00.4000
Please help
Ron

https://www.screencast.com/t/qnLsy12za

[acourtjester]

AS I said above the G31 command is for a probe input signal, and it seen it does not get it and that is why it stops there. see attached image of the input info about the probe. Another thing I find odd is why are you raising the Z to 40" I raise mine to 1"
some other background info would help like is this a new table you are setting up, what post processor are you using.

probe.JPG (32.41 KiB) Viewed 908 times

probe.JPG (32.41 KiB) Viewed 908 times

[djreiswig]

I think it's 0.4000

[Plasron]

AS I said above the G31 command is for a probe input signal, and it seen it does not get it and that is why it stops there. see attached image of the input info about the probe. Another thing I find odd is why are you raising the Z to 40" I raise mine to 1"
some other background info would help like is this a new table you are setting up, what post processor are you using.
probe.JPG

Thank you acourtjester
I was using the wrong processor and I just found out where to change the Z 40.000 to Z 1.5

Thank agin
Ron

[Plasron]

I think it's 0.4000

Thanks

[acourtjester]

Happy to help have fun Ron