I realized today that my +5 light on the PWM sensor wasn't working. I thought this meant that my Cat-5 cord was maybe not working properly, so I replaced the cord. Lo and behold, the +5 light still didn't come on, even with power. I took the PWM sensor off of the machine, and pushed the button on the back that would activate the "test active" light, only to find that the light didn't activate.
I have power and air hooked up to the machine, so I don't believe that is the problem.
PWM Sensor LEDs not working
-
djreiswig
- 4.5 Star Elite Contributing Member
- Posts: 2024
- Joined: Thu Nov 19, 2015 10:02 pm
- Location: SE Nebraska
Re: PWM Sensor LEDs not working
Bad led? Can you measure the 5v with a meter to confirm if it is there or not?
2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)
-
Arclight Dynamics Tech
- 1 Star Member
- Posts: 24
- Joined: Mon Jul 08, 2019 10:51 am
Re: PWM Sensor LEDs not working
Hey there!
Are you experiencing any cut issues? If so it could be something related to that light not being illuminated. That +5 light should be on but it is quite possible that it burnt out.
If you would like you can reach out to us via email at:
Support@arclightcnc.com
Or call at:
866-222-2154
Thanks!
Are you experiencing any cut issues? If so it could be something related to that light not being illuminated. That +5 light should be on but it is quite possible that it burnt out.
If you would like you can reach out to us via email at:
Support@arclightcnc.com
Or call at:
866-222-2154
Thanks!
