will this work? I have a small dorm fridge not being used. could I run a 50ft rubber airline in a bucket of water in the fridge to cool the air then have a separator on the line coming out. Yes I am cheap (and low on cash) but need dryer air. if not rubber air line how bout pex? any other ideas? Tryin to use what I have
thanks
air dryer?
-
- 3 Star Elite Contributing Member
- Posts: 465
- Joined: Sun Oct 31, 2010 1:26 pm
- Location: Kannapolis,NC
- Contact:
air dryer?
CandCNC
Mach3
Sheetcam
Draftsight
Hypertherm 65 machine torch
Millermatic 210
Passport plus
Spoolmate 150
Miller Bobcat 225
http://benzweldingandfabrication.com/
https://www.facebook.com/pages/Benz-Wel ... 468?ref=hl
Mach3
Sheetcam
Draftsight
Hypertherm 65 machine torch
Millermatic 210
Passport plus
Spoolmate 150
Miller Bobcat 225
http://benzweldingandfabrication.com/
https://www.facebook.com/pages/Benz-Wel ... 468?ref=hl
-
- 2.5 Star Elite Contributing Member
- Posts: 240
- Joined: Tue Nov 17, 2009 10:39 pm
- Location: AR, USA
Re: air dryer?
Here is a link to a past thread on that subject.
http://www.plasmaspider.com/viewtopic.p ... yer#p14899
http://www.plasmaspider.com/viewtopic.p ... yer#p14899
- jmsrbrt
- 3 Star Member
- Posts: 382
- Joined: Mon Dec 08, 2008 5:24 pm
- Location: San Marcos, TX
- Contact:
Re: air dryer?
I have 50 feet of PVC line coming out of my air compressor, running up and along a ceiling beam, then returning to my dessicant dryer, then the plasma cutter. Seemed to work okay for me if I drained the compressor and line before cutting.
Recently bought a dryer and a one of those filters with what looks like toilet paper, between the dessicant and the plasma cutter. My cuts seem to have improved, but that was an additional + $600 expense.
Recently bought a dryer and a one of those filters with what looks like toilet paper, between the dessicant and the plasma cutter. My cuts seem to have improved, but that was an additional + $600 expense.
Torchmate 2 with ATHC & Water table
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas