New Member here and Ive been fabricating many years at my small volume sheet metal shop on a Torchmate 3 table we built from a kit.
Thanks in advance for all the priceless shared knowledge from my fabricating Brothers and Sisters!
Jon Blair
Odessa TX
New Member
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 11432
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: New Member
Welcome aboard Jon! I don't have a Torchmate table, but I do have the TMCad program and find it very handy for certain tasks. What sorts of sheet metal do you make? When I think of a sheet metal shop, I usually think ducts, drip edging, and such.
David
David
-
JDB
- 1/2 Star Member
- Posts: 4
- Joined: Thu Dec 12, 2024 3:02 pm
Re: New Member
Thanks David! In the past we've built everything from SS evaporative coolers to SS countertops and commercial vent hoods and ducting. Lots of restaurant related equipment etc.
Jon
Jon
