Cutzilla

[Hole Shot Garage]

Anybody using the Cutzilla ? Do you like it ? is it user friendly ? It looks pretty complete but there would have to be a calculation i think to allow for the offset of the engraver.. Any input appreciated..

[acourtjester]

YOu may want to look at easyscriber, shown on this site and sold from this site too. Nowhere near the cost or noise.
viewforum.php?f=172

[Hole Shot Garage]

Easyscriber will not work on my torch.. been talking to him. That was my first choice .. I have bought the Cutzilla look forward to trying it out..

[b165203]

If you use Sheetcam the offsets are very easy to edit in the plasma with scribe post.

[adbuch]

The Cutzilla looks like a quality product. This is a similar concept to the Engraving Attachment I purchased several years ago for my Plasmacam. These air scribes work great, but are indeed noisy.
David

https://cutzilla.weeblysite.com/

Cutzilla.jpg

[btburn]

I ordered the CutZilla scriber setup from Josh. I'm impressed, especially for the price. Many scribe setups are more expensive and don't include the scriber. Josh used quality components and it includes the scriber as well. Josh built to my specs for my table (Dynatorch Super Bee) since my M8/M9 voltages were opposite of most. I had to make a bracket, run some wires, run an air line and fiddle with the offsets and that's it. I highly recommend Josh and his CutZilla scriber.