Introduction but not my first post.

bnflette · Post by **bnflette** » Fri Apr 26, 2019 2:24 pm

I and Im not exactly new to the world of CNC plasma and my introduction is probably overdue. I've been struggling for about a year now.

My table setup consists of a 4'x4' table a Cutmaster 82 with automation board, an Sl100SV Mechanized torch, and Proma THC. The software I use is Inkscape, Sheetcam, and Mach 3. I also have a Snap on MM140sl Mig , Lincoln promig 180, Lincoln sp125 mig, Everlast Powertig250ex, Harbor freight bandsaw, 12" cold cut saw, Jd2 model32 bender, and some other grinders, sanders, and a decent collection of hand tools.

I can make successful cuts but I know just enough to be aware of how much I don't know. The list things relating to CNC plasma, that Im don't understand is extensive. This site has been a great source of information over the past year and I expect it will continue to be.

Thank You

Post by **acourtjester** » Fri Apr 26, 2019 4:10 pm

Welcome aboard, sounds like you have the tools, collect your questions, with the large variety of people here there will be answers.
Do you have a shop or are you a hobbiest, what type of things light you fire, plasma speaking

Post by **plasmanewbie** » Fri Apr 26, 2019 8:27 pm

This site was the secret to my success when it came to getting started with my table almost 10 years ago. Very grateful for that and happy to help if I can.

Introduction but not my first post.

Introduction but not my first post.

Re: Introduction but not my first post.

Re: Introduction but not my first post.