post processor not able to process

[Jason@bc]

I have just updated my processor to rev26 and for some reason when I put in peck pierce/drill marks it isn't able to post process it, just plain cutouts it

works fine, any help is welcome, thanks.




Here is a screenshot of the message error that pops up.

[mjfabshack]

I know that this is a old posting but I have ran into this same error.

[TJS]

Go to the CandCNC forum. There is a thread about this. There is a new version of post 27e I think. I have been trying for a couple of days to get it to work. Again. I am new at this. Please post your screen shot of your tools for this in your sheet cam. I am doing something wrong even after the 27e post.

http://www.candcnc.net/supportforum/vie ... k&start=10