post processor not processing

[Jason@bc]

Hey all, I'm having trouble with a cut-file on command cnc, when I ran the post processor in sheetcam it said there was an error, but after a couple tries it went through, but it didn't do the peck-pierces that it was supposed to, here is the ngc, wonder if someone can tell me what I'm doing wrong in sheetcam.

[Jason@bc]

here is the ngc file

[WyoGreen]

Here is what was in the file.

(Filename: slides for manure spreader .ngc)
(Post processor: CandCNCPlasmaLLCNC-rev26.scpost)
(Date: 01/21/2019)
G20 (Units: Inches)
F10.0
G90 G40
G64 P0.010 Q0.001 (tracking tolerances set to 0.01)
M68 E0 Q10
(Part: pusher-front for manure spreader)
(Operation: Drill, 0, T2: 85 amp 3/16 steel, 0.0156 inch Deep)
M68 E0 Q900 (Global DTHC ON/OFF is ON )
G4 P.1

There is nothing in there to do any cutting. There have been several posts over on the Sheetcam forum by people having similar problems. If I remember right, there was a corrupted license file causing the trouble. You might do a search over there.

Steve

[Jason@bc]

I will look over there then, thanks.