Al,
I have version 25. Does BOBCAD/CAM have a post processor for my Vicon table? I have the Vicon 3.4 software. I would rater use your software for my post processor than the Vicon software because their software is designed more for the HVAC industry.
Vicon Post processor
-
MidAmericaIron
- 2 Star Member
- Posts: 59
- Joined: Thu Dec 13, 2012 9:37 pm
- Location: St. Louis, MO
-
aldepoalo
- 1 Star Member
- Posts: 17
- Joined: Mon Jun 06, 2011 1:05 pm
Re: Vicon Post processor
Hello MidAmerican Iron,
I am not sure if we have a Vicon post or not. I would have to check our www.bobcadsupport.com page and look. My assumption is if this machine takes g-code for lines and arc and uses an Mcode for cutter on and off it shouldn't be a problem.
I did a quick search and didn't find the post on our website. That being the case it wouldn't take much to set one up.
I am not sure if we have a Vicon post or not. I would have to check our www.bobcadsupport.com page and look. My assumption is if this machine takes g-code for lines and arc and uses an Mcode for cutter on and off it shouldn't be a problem.
I did a quick search and didn't find the post on our website. That being the case it wouldn't take much to set one up.
