Sheet cam

Patrick Waite · Post by **Patrick Waite** » Tue Oct 06, 2015 2:14 pm

OK. The table is working. Now this is where it get troubling. I exported my drawing from Corel draw x5 and import it to sheet cam. I hit my plasma cut. Set up all my setting and every thing looks good. I hit the post processer. I'm get an error. Saying the evaluation limit reached. What the hell is this.

_Ogre · Post by **_Ogre** » Tue Oct 06, 2015 2:22 pm

you need to enter your license number in sheetcam

Patrick Waite · Post by **Patrick Waite** » Tue Oct 06, 2015 3:51 pm

Thank you. Not sure why Candcnc could not tell me that. Been messing with this software for day. Unbelievable I just new there was something wrong

Patrick Waite · Post by **Patrick Waite** » Tue Oct 06, 2015 6:50 pm

I just wanted to thank you for getting back to me about the license not being posted in my sheet cam. I guess I need to slow down and think what I am doing more. Everything working fine now. Going to try and cut something out with my new upgrade from Candcnc.

_Ogre · Post by **_Ogre** » Thu Oct 15, 2015 4:45 pm

Not sure why Candcnc could not tell me that.

candcnc is not sheetcam, though they should have known what the 'evaluation limit' was

Sheet cam

Sheet cam

Re: Sheet cam

Re: Sheet cam

Re: Sheet cam

Re: Sheet cam