Fan Question

Hypertherm Plasma Cutter discussion forum.
Post Reply
sodfarmer
2.5 Star Member
2.5 Star Member
Posts: 170
Joined: Sun Dec 19, 2010 2:54 pm
Location: Van Wert, Iowa

Fan Question

Post by sodfarmer »

I have a 1000 on my table and was curious to know how much the cooling fan should come on. I ran a job the other day it was 10ga steel cutting with fine cuts and it had around 500 total cut inches. The fan never came on and was curious to see if this was normal.
Top
Post Reply

Return to “Hypertherm Plasma Cutters”