PlasmaCam and Samson

[GeorgeNewman]

Here is a little something I did 2 or 3 years ago to help keep tip ups from causing so many problems. Everything is 16Ga hrs or crs. SS would work but be expensive. I cut the pieces from the scrap between whatever I was doing. After a little while you can have sections of the table filled with these little buggers and if you cut smaller things there it helps keep problems down. It is a pcm because it only applies to PlasmaCam or Samson systems.

George

[rpage]

Have any photos of them on your table? Just would like to see them in use is all

Thanks for posting!

[DumOleBob]

Highly Klever George! Thanks

[GeorgeNewman]

I haven't used them much lately because I have been doing fairly large pieces of production work. When I need them, I cut what I need from drop that is lying around. They end up at the scrapyard.

George

[BrianMick]

hey george that is accually a great idea.... in fact that is kinda what i need to fill the void over the modified slats for tubes that i designed ..........thanks
Brian

[GeorgeNewman]

I've thought of all kinds of stuff to do to the table. A few of my ideas worked. Most didn't. I'm still trying to figure out how to elevate the rails and gantry. It's a bit harder than the PlasmaCam table. I think we just helped each other more than we yet know. Thanks.

George

[Eagle Mtn Metal Works]

Hi George
I think that there is a picturer in the files on the plasma pig web site to raise the rails for your Samson. It,s a way to have an adjustable table to be able to cut 10" I beams and more. Ck it out.