Looking For A Platemarker Set Up

[Thumper]

Does anyone have a plate marker set up for a plasmacam table? Or better yet would anyone be willing to build me a set up? I'll pay whatever it's worth to ya meaning I'll pay your shop rates for you to do it plus the equipment needed. I figure it'll be cheaper to pay to have it done by someone that's done it before verses my screw ups trying to get it right lol I've never even seen one set up so I'm clueless as to how to go about it... Have cash or I'm sure I could come up with some type of shop equipment as trade bait.. Or I have thousands of cut files I'll share plus cash for the materials used. I'd like to try one out on the small table leaving the large table for cutting. Holla lol

[_Ogre]

You can pay a lot for a prefab because the parts cost a lot. Or you can shop ebay and save some serious cash. An air slide, an air scribe and a bracket off your plasma table is all it takes.

I have$100 in my scribe setup, the commercial kits cost up to$2800 .not sure what software your table runs or what post processors you have.

[Joe Jones]

Silly question: What is a Plate Marker?

[JEd]

Silly question: What is a Plate Marker?

https://www.youtube.com/watch?v=VhYPtYJerYQ

[Rockenjvdesign]

I wonder why plasma cam don't offer it? im looking for one too can anyone point me in the right direction

[CNCCAJUN]

I wonder why plasma cam don't offer it? im looking for one too can anyone point me in the right direction

Can you imagine how much that would want for it?

Steve

[Rockenjvdesign]

Probably just as much as the machine

[kkroger]

I wonder why plasma cam don't offer it? im looking for one too can anyone point me in the right direction

They do offer it. They even have an advertising video of their on You Tube.

[Metriccar]

That's not Plasmacam's. Someone just put it on theirs. I'm surprised it works considering. The carriage will lift up when the torch is driven into the metal. I called Plasmacam and they said they were discussing making one but if they do it will be a while. And if they do, yes they'd want a bunch of money just like everything else they sell. I personally am not sure how long the Plasmacam would hold up to routers or scribes so don't use it for that.

[1MORECUT]

Here's one that I'm working on.Just waiting for air fitting and air line.
I been running router on my table for 4 years with no problem.

John 8-)www.youtube.com/watch?v=pHoklaZ6ljY

[Joe Jones]

Can you imagine how much that would want for it?

Steve

"$ (something)998.00" I would imagine!