greencut cutting fluid for your water table

[Arc Innovations]

Does anyone know if this greencut stuff works for cutting aluminum?
I was always told you couldn't cut aluminum with a water table because it gave off a hydrogen gas. But someone told me he saw a place where they used this greencut stuff mixed into the water and it was safe.
Is anyone using this stuff? Does it keep the water from evaporating slower?

Thanks, Gary

[MidAmericaIron]

Google "Plasma Quench"

[northwesternmachine]

We have had good success with the greencut for cutting aluminum. We get ours from here:

http://www.lubeclean.ca/cutting-fluids- ... litre-pail

When we had questions about using greencut before we bought it, I called lubecorp on their 800 number and they were really helpful. After what I have read, I would not use plasma quench. The nitrite in it can change into nitrates under the heat of the torch. Nasty stuff to breathe. I want to be around in a few years for my grand kids. Not dying of cancer.

Just my 2 cents.