Looking for Design Software

[doubled1960]

I'm new to this. Which software is the most user friendly for creating and scanning. My son uses Flexi for Vinyl. I've tried using it but it seems awful complicated. Of course it may just be me. Any suggestions would be appreciated.

Equipment
ShopSabre 4x8 Sidekick set up for plasma or Router.

[plasmapros]

If your machine did not come with design software I would recommend CorelDRAW. It will do almost anything you want and there is good support here on plasmaspider.

[Gamelord]

I use Corel for most all of my drawings.

[Fountaine]

If you get 10 replies I think you will also get 10 different answers.

I am using BobCad V24. I was totally new to all of this and found their software, I don't want to say easy, not bad to understand and use.

I think they have a good support system and they talked in laymen's language when they understood I was below rookie status.

Good luck....

[kbenz]

I use acad (draftsight now) for all my stuff. but thats all i've been taught to use for the past 18 years