Can someone help me and explain how I can make this drawing more straight. Its is very choppy to me eyes!
Thanks in advance!
Help making drawing not SO choppy!
-
dunnmfg
- 2.5 Star Elite Contributing Member
- Posts: 128
- Joined: Wed Nov 14, 2012 5:14 pm
-
beefy
- 4.5 Star Member
- Posts: 1503
- Joined: Fri Jan 18, 2013 3:19 am
Re: Help making drawing not SO choppy!
Downloaded the file twice but couldn't open in X5
2500 x 1500 water table
Powermax 1250 & Duramax torch (because of the new $$$$ync system, will buy Thermal Dynamics next)
LinuxCNC
Sheetcam
Alibre Design 3D solid modelling
Coreldraw 2019
Powermax 1250 & Duramax torch (because of the new $$$$ync system, will buy Thermal Dynamics next)
LinuxCNC
Sheetcam
Alibre Design 3D solid modelling
Coreldraw 2019
-
dunnmfg
- 2.5 Star Elite Contributing Member
- Posts: 128
- Joined: Wed Nov 14, 2012 5:14 pm
Re: Help making drawing not SO choppy!
I did this in x6....
-
beefy
- 4.5 Star Member
- Posts: 1503
- Joined: Fri Jan 18, 2013 3:19 am
Re: Help making drawing not SO choppy!
Can you save it as an X5 file then that should increase the number of members that could help you. Quite a lot seem to be using X5.
2500 x 1500 water table
Powermax 1250 & Duramax torch (because of the new $$$$ync system, will buy Thermal Dynamics next)
LinuxCNC
Sheetcam
Alibre Design 3D solid modelling
Coreldraw 2019
Powermax 1250 & Duramax torch (because of the new $$$$ync system, will buy Thermal Dynamics next)
LinuxCNC
Sheetcam
Alibre Design 3D solid modelling
Coreldraw 2019
-
SignTorch Vector Art
- 4 Star Member
- Posts: 860
- Joined: Fri Dec 03, 2010 7:57 pm
- Location: SE TX
Re: Help making drawing not SO choppy!
- tommy1.jpg (12.65 KiB) Viewed 790 times
- tommy1.jpg (12.65 KiB) Viewed 790 times
I don't use corel trace but it looks like it needs more detail and less smoothing
easier to remove extra points than to reshape excessive smoothing
