hypertherm powermax 45 and ohmic addon

Skinnedrabbit · Post by **Skinnedrabbit** » Fri Jan 18, 2013 11:15 am

Hi ,
ive just ordered a ohmic kit from tom at candcnc . Before it comes , do I need to order a different shield for fitment .ive got 50 sheets of 2mm st/st to cut with no plastic on so thought it would be a good upgrade to go for .I have the machine torch fitted . thanks Rob

Craig · Post by **Craig** » Fri Jan 18, 2013 2:54 pm

Rob, you will need the shielded nozzle and shield plus omic retaining cap #220719 I think. Craig Johnson

Skinnedrabbit · Post by **Skinnedrabbit** » Fri Jan 18, 2013 4:52 pm

Ok I'll order up thanks

Post by **plain ol Bill** » Fri Jan 18, 2013 6:43 pm

See this post
http://plasmaspider.com/viewtopic.php?f=60&t=8766

Skinnedrabbit · Post by **Skinnedrabbit** » Fri Jan 18, 2013 11:32 pm

Thanks bill

jimcolt · Post by **jimcolt** » Mon Jan 21, 2013 10:36 am

Here is a picture of the consumables from a Powermax45 operators manual. The ohmic retaining cap and the mechanized shield are necessary. Use these parts even if you are using a hand torch for your machine cutting.

Jim Colt

: mechanized consumables.png (24.43 KiB) Viewed 1127 times

: mechanized consumables.png (24.43 KiB) Viewed 1127 times

Skinnedrabbit wrote:Hi ,
ive just ordered a ohmic kit from tom at candcnc . Before it comes , do I need to order a different shield for fitment .ive got 50 sheets of 2mm st/st to cut with no plastic on so thought it would be a good upgrade to go for .I have the machine torch fitted . thanks Rob

Skinnedrabbit · Post by **Skinnedrabbit** » Thu Jan 24, 2013 3:32 pm

Thanks for the picture jim

hypertherm powermax 45 and ohmic addon

hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon

Re: hypertherm powermax 45 and ohmic addon