Another Jim question
-
plain ol Bill
- 3.5 Star Elite Contributing Member
- Posts: 687
- Joined: Fri Aug 15, 2008 6:22 pm
- Location: Tenino,WA
Another Jim question
Thanks for the answer about the omnic sensor question I had Jim. When I use the correct end cap with the fine cuts does the cut height remain at .080? You mentioned it sticks down a little further that the unshielded fine cuts and that prompts this question. Thanks for being there for all of us Jim.
plain ol Bill
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
Hypertherm 1250
Duramax machine torch
Corel Draw X6
Sheetcam
Mach3
5 x 10 self built table
Lots of ineptitude
-
jimcolt
- 5 Star Elite Contributing Member
- Posts: 3087
- Joined: Mon Jul 20, 2009 11:18 pm
- Location: North Carolina
Re: Another Jim question
Bill,
I posted a reply to this yesterday...but perhaps I hit the wrong button! I run the height at .06" with the ohmic shield...seems to work well. The manual is unclear on this.
Jim
I posted a reply to this yesterday...but perhaps I hit the wrong button! I run the height at .06" with the ohmic shield...seems to work well. The manual is unclear on this.
Jim
plain ol Bill wrote:Thanks for the answer about the omnic sensor question I had Jim. When I use the correct end cap with the fine cuts does the cut height remain at .080? You mentioned it sticks down a little further that the unshielded fine cuts and that prompts this question. Thanks for being there for all of us Jim.
