JD's Garage Triangle bracket

Post by **ArcticMonkey** » Mon May 19, 2025 9:13 pm

I am trying to build the JD's Garage XL table to the dimensions of a 4'x8' table.
In the interest of time, I am going to buy the 3D printed parts and sheet metal parts from them to speed things along.
Does anyone happen to have a DXF for the JD's garage triangle bracket that they would be willing to share?
Thanks Todd

Post by **acourtjester** » Mon May 19, 2025 11:52 pm

Do they not supply that with the plans, I would assume if you buy the parts, you would get the plans too????

Post by **adbuch** » Tue May 20, 2025 1:04 am

I agree with Tom. If you are building from their design, then I would have assumed you had the plans. If the plans don't include this bracket, then contact them and have them send you the file.

David

Post by **Joe Jones** » Tue May 20, 2025 2:38 am

Would these work?

http://www.lowes.com/pd/Simpson-Strong- ... 1002739736

http://ironsupports.com/products/univer ... jEQAvD_BwE

Post by **TJS** » Tue May 20, 2025 6:59 am

I have seen a lot of posts on JDs table. Even a couple vids I glanced over. Not even sure what this said bracket does. The second link Joe posted seems to be a little stronger but maybe that is the pic. Does it have to be 3 dimensional or can it be flat.
T.J.

JD's Garage Triangle bracket

JD's Garage Triangle bracket

Re: JD's Garage Triangle bracket

Re: JD's Garage Triangle bracket

Re: JD's Garage Triangle bracket

Re: JD's Garage Triangle bracket