Torchmate Signal Generator Problems

[DakotaDesignSolutions]

I own a Torchmate 3 table that originally had a 501A signal generator but that board is now bad. I tried retro-grading to a 401A signal generator but it has the V0T9L chip which does not work with the torchmate 2 or 3 driver software. Torchmate does not list the version 1 of the driver software on their website and support does not have access to it. I was wondering If someone had a 501A, a 401A with a V0T9M chip or a pc with the driver software version 1 installed that I could purchase. Any help would be appreciated as I cannot afford to purchase a new board from flashcut. thanks.

[adbuch]

You might consider posting in the Classified section as well. Also on the Torchmate forums and facebook groups.

David

[DakotaDesignSolutions]

You might consider posting in the Classified section as well. Also on the Torchmate forums and facebook groups.

David

I'll look into those options, thank you.

[adbuch]

You might consider posting in the Classified section as well. Also on the Torchmate forums and facebook groups.

David

I'll look into those options, thank you.

You are quite welcome!

David