Utah new guy

[BaggedNissan98]

Hello everyone, new to the forum....not new to using a plasma, for fabrication and building purposes....mainly looking to gain further knowledge of the machine I have, and whether it will be suitable to use with a langmuir table or an arcdroid setup

Current machine is a Hypertherm powermax 30air

[plasmanewbie]

Welcome! Not sure if it is a blow back start or not but if it is, you can certainly use it. I don’t expect you’ll be able to cut for very long without giving it a break since the built-in air compressor will only be able to do so much, but it would probably be a great place to start. You dont have a cnc yet?

[68rscamaro]

Welcome. I'm in Idaho so not too far away. The plasma unit you have won't be a good fit for a plasma table imo.
Pretty sure the 30's never came with a cpc and not sure it can even be added to them. Even if you do get it to work you'll quickly wish you had a bigger machine.