Muskie DXF Plasma Design

Post by **claytoncad** » Wed Dec 18, 2024 1:07 am

I was asked to make this as a Christmas gift, turned out great thought I'd share.

MUSKIE.dxf

Muskie.jpeg

Post by **Joe Jones** » Wed Dec 18, 2024 1:28 am

That is well done! About ... 16 inches long? I think I would use "Alien Tape" to fasten a heavy block of ceramic, or steel, or something onto the base plate so it is not top heavy. If it fell over, it could scratch the furniture.

Joe

Post by **adbuch** » Wed Dec 18, 2024 2:00 am

Very nicely done! At just a tad over 18" long, this one will cut very nicely. Great work on your design.
David

muskie fish image.jpg

Post by **claytoncad** » Wed Dec 18, 2024 5:22 am

Thanks guys. I do a few stand ups here and there, I’ve got a couple more I’ll post soon. I’ll try and get some more files on here this week.

Post by **adbuch** » Wed Dec 18, 2024 5:49 am

claytoncad wrote: Wed Dec 18, 2024 5:22 am Thanks guys. I do a few stand ups here and there, I’ve got a couple more I’ll post soon. I’ll try and get some more files on here this week.

I will look forward to seeing more of your creations.
David

Post by **hardworker** » Fri Dec 20, 2024 5:15 pm

Awesome file, thanks for sharing

Muskie DXF Plasma Design

Muskie DXF Plasma Design

Re: Muskie

Re: Muskie

Re: Muskie

Re: Muskie

Re: Muskie DXF Plasma Design