Just became a member .
Been creeping for some time learning the tricks and tips .
Was running torchmate classic , now upfitted to flashcut 10.
Learning all over again, but the knowledge base here has been good, Thanks to all here
Old creeper new member
-
SegoMan DeSigns
- 4 Star Member
- Posts: 984
- Joined: Sat Jan 06, 2018 4:45 pm
Re: Old creeper new member
Welcome to the forum!
-
dynonsx
- 1/2 Star Member
- Posts: 2
- Joined: Mon Sep 25, 2017 2:11 pm
Re: Old creeper new member
thank you!
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 10135
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Old creeper new member
Welcome aboard dynonsx! What software are you using for your cad/cam? I purchased a single seat license for TMCad several years ago as it has some tools I wanted to check out. I like it for certain things - in particular the Polyarc tool is very handy. What sorts of projects are you cutting with your Torchmate table? Perhaps share some photos so we can see what you are up to.
Thanks,
David
Thanks,
David
