Miller Spectrum 2050 Drag Tip or Machine Tip?

[Sierevello]

I was searching for cutting amperages for a Miller Spectrum 2050 and came across a post by Jim Colt.

In the post below Jim Colt suggested to use a machine tip to hand cut with over a drag tip on a Miller Spectrum 2050:

https://plasmaspider.com/viewtopic.php? ... 74f0b937f9

What is the reasoning for using the machine shield instead of the drag shield for hand cutting?

Thanks You for your help. I tried to message Jim but I know he has retired and I am not sure how often he gets on the forums any more.

-Steve

[weldguy]

Hey Steve

Because the 2025 is being used on a cnc table I believe Jim Colt is suggesting to use the machine shield despite the fact that you are using a hand torch on the cnc machine.

[Sierevello]

That makes sense.

Thank You!