Messer Camera Offset problems

[Napualima]

We have a Messer Titan 3 and we recently replaced the camera, but now the camera is out of alignment with the torch head so it's a few degrees off. None of us remember how to fix the offset in those situations and the manuals for Messer only say that the offset should be at 0(x),0(y), but that doesn't change anything. Does anyone know how to fix that? Messer hasn't been known to be very helpful in the past and if there's a less painful approach to this that's the route we want to go. Thank you.

[weldguy]

Is any mechanical adjustment able to be done if you loosen the mounting hardware and tweak it a little. Can you change the offset in the software from 0x0y to whatever you need to achieve perfect alignment?