I have a Hypertherm 65sync and a Samson 5x10. It was doing just fine now when I got to cut the table travels throw the cut file but the torch never activates. Has anyone else run into this? Any help would be greatly appreciated, and yes I’m new to this Cnc plasma game.
Josh
65 sync
-
rdj357
- 4 Star Elite Contributing Member
- Posts: 1185
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
Re: 65 sync
Make sure you have the Auto Cut turned on. This is usually on so it's easy to forget that it even exists if it gets bumped off on the controller or the keyboard (Alt-A). Look in the Machine menu and make sure it has a check mark or on the controller for the LED by Auto Cut.
Robert Johnson
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2187
- Joined: Fri Apr 17, 2009 11:48 am
Re: 65 sync
Also have a look for an error being displayed on the front of your plasma cutter.
-
Skidmore
- 1 Star Member
- Posts: 14
- Joined: Wed Sep 20, 2023 9:24 pm
- Location: Montana
Re: 65 sync
No errors on plasma or table, ground is good, air PSI is good.
-
Skidmore
- 1 Star Member
- Posts: 14
- Joined: Wed Sep 20, 2023 9:24 pm
- Location: Montana
Re: 65 sync
Rdj357,
You where right on the money thank you for your help.
You where right on the money thank you for your help.
-
rdj357
- 4 Star Elite Contributing Member
- Posts: 1185
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
Re: 65 sync
No problem, glad to help! Glad you're making sparks again!
Robert Johnson
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2187
- Joined: Fri Apr 17, 2009 11:48 am
Re: 65 sync
Good call Robert 
