Dynatorch scribe

[454matt]

Need some help from someone with a Dynatorch Super B or similar running the XLS post processing software. Trying to use the factory supplied air scribe on my table but the solenoid on the head that sends air to the cylinder and scribe is not actuating. What are the required settings in the Dynatorch XLS software. Do I need to go to the "Marking" tab and input any values?

I've scoured this forum and the internet for 4 days and cannot find the answer. All the manuals Ive found online and my own do not even discuss the "Marking" tab or show any pictures of it existing.

Thanx

Matt

[ROKCRLER]

Matt, I'll get you my settings hopefully tomorrow.
What post are you using?
I started a thread about it where member djresiwig and I were playing with shrub settings for my dynatorch. Settings might be there too.

Here's the thread..viewtopic.php?f=100&t=35497

[454matt]

That would be fantastic. I use SheetCam and Dynatorch XLS version 4.2.1.182

Thanx

Matt

[ROKCRLER]

Matt, have you gotten this figured out?

[454matt]

nope.. I can't find any answers anywhere.. I can not figure out how to send air to the electric air solenoid on the cnc head..

[ROKCRLER]

Sent you a PM.