4lb box
Plasma Quench Recipe for Water Table Use
-
ROKCRLER
- 3 Star Elite Contributing Member
- Posts: 656
- Joined: Sun Sep 30, 2018 5:19 pm
Re: Plasma Quench Recipe for Water Table Use
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
4x8 Dynatorch
PM85
~Mo~
PM85
~Mo~
-
PlasmaDon
- 2 Star Member
- Posts: 99
- Joined: Wed Nov 15, 2023 6:44 pm
Re: Water Table Use - Plasma Quench Recipe
Would not the quench only be at the cut edge ?Joey wrote: ↑Mon May 23, 2011 12:57 am I just finished my water table. Ok, it will be just like everything else, never finished. haha I had to cut a bunch of 1 3/4 inch and 1 1/4 inch plate. I had to lower the water level to minimize any quenching of the plate. I had a fun time drilling the 1 9/16 holes in the parts that got splashed. I thought I would pass this warning to anyone who might be using their water table on hardenable steels. Just something I didn't think about until it was too late. I ended up with the water about three inches below my material. It still cut down on the smoke a lot.
Not keeping the plate cool, would that not anneal the whole piece ?
