*New product Laser Cross Hairs (Laser Line Pro) and Red dot alignment laser

[BTA Plasma]

Line Laser Pro


*Fits either 1-3/8" or 1-3/4" torch bodies
*Powerful 200mw lasers
*Easily calibrate
*Flipable to allow different alignments
*Plugs into CommandCNC Aux outputs or Flashcut Aux output power block
*Create on screen button with CommandCNC
*Easy plate alignment


Check it out here
https://starlabparts.com/ols/products/l ... wermax-125



Find the edge of your material easily with the Star Lab Laser Pointer!

Torch mounted laser pointer features

*Easy twist focus
*Slot for accurate placement on torch gear rack
*Easily clamps to any torch 1-3/8" body
*Has 4' lead with x2 AA battery case
*1.25" distance from torch center to laser center

CommandCNC users there is a firmware update for laser pointer center that has a laser pointer offset setting in the manual section.

https://starlabparts.com/ols/products/t ... er-pointer

[tinspark]

That looks super handy!

[plasmanewbie]

Pretty cool! I suspect this could be adapted to any table, is there a manual on/off switch for those who cannot control it through software?

[SegoMan DeSigns]

The only problem with a laser alignment system on a plaz table is the smoke / dirty water splashing back and messing up the focus. You need to offer plastic caps for covers when not in use.. I need to change mine out "again" others have posted on the forum that a green laser is better for visibility..

[djreiswig]

Pretty cool! I suspect this could be adapted to any table, is there a manual on/off switch for those who cannot control it through software?

If you look at the pics, it's run with AA batteries and there is a switch on the battery case. It doesn't connect to the table wiring.

[adbuch]

This is a nice looking setup. Is it only offered for machine torches, or is there a version for hand torches mounted to the cnc plasma table?

Thanks,
David

[plasmanewbie]

Pretty cool! I suspect this could be adapted to any table, is there a manual on/off switch for those who cannot control it through software?

If you look at the pics, it's run with AA batteries and there is a switch on the battery case. It doesn't connect to the table wiring.

Ah ok, thanks djreiswig, I did not see that in the pics

[BTA Plasma]

The dot laser has a x2 AA battery holder but the line lasers are too powerful for AA batteries and are run on a standard DC adaptor. We dont make these for hand torches because we dont integrate hand torches like all mfgs but one. Apologize to the owners that use hand torches.

[adbuch]

The dot laser has a x2 AA battery holder but the line lasers are too powerful for AA batteries and are run on a standard DC adaptor. We dont make these for hand torches because we dont integrate hand torches like all mfgs but one. Apologize to the owners that use hand torches.

Thanks for your reply. I own a Plasmacam which will accept either hand torch or machine torch. I happen to use the hand torch and that is why I was asking. I know that some of the Langmuir tables have mounts for hand torches, and I expect some of the others may as well. In any case, you have come up with a great idea and I expect it could be easily adapted to the hand torch mounts.

David