Poor Quality Cuts
-
- 1 Star Member
- Posts: 14
- Joined: Thu Jan 19, 2023 11:36 am
Poor Quality Cuts
tried cutting maltese cross fire dept can not get clean lines. 12 inches x 12 inches seems lose rungs in ladder tried it with different feed rates still same
-
- 4.5 Star Elite Contributing Member
- Posts: 2179
- Joined: Fri Apr 17, 2009 11:48 am
Re: poor cuts
12x12 isn't very big and I don't know what your file looks like but ladder rungs sound very thin and the smaller you try to cut this piece the thinner the rungs will be. If you would like to post the file your cutting I would be happy to have a look but I suspect the lines are just too close and cutting into each other.
- acourtjester
- 6 Star Elite Contributing Member
- Posts: 8162
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: poor cuts
Posting an image of the actual cutting will also help, The old "picture is worth a thousand words"
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
- 6 Star Elite Contributing Member
- Posts: 10063
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: poor cuts
Agreed! Post your file along with some photos of your cut results so it will be easier for use to try to help you.
David
David