Request for information about building a THC controller

[enddccc]

Hi,
I'm new to this field and I need some information as I'm building a THC controller for a plasma with contact ignition. Can you tell me what the maximum voltage and frequency are? Also, does anyone have any voltage peak readings on an oscilloscope that I could use to observe the waveform and ripples?

[robertspark]

viewtopic.php?f=3&t=35154#p222381

[enddccc]

viewtopic.php?f=3&t=35154#p222381

Hi,
Thank you for the information. Until now, I have been more focused on continuing with Mach3. Are there any benefits of using LinuxCNC over Mach3?
and to be honest, I'm finding myself in Mach3 more.

Thankss

[robertspark]

there are a lot of benefits to linuxcnc but use whatever you are happiest with and works for you.

[enddccc]

Hi,
Thanks for the info.

End.