Cabin sign

[Witt32]

Good morning everyone. I'm not new to the forum but I haven't posted much, if at all. I've gotten lots of help from others posts though. You guys and gals are a wonderful source of information.

I'm looking for help converting this file to a DXF to import to Fusion 360 or straight to sheetcam. I'm hoping to do it in two layers, back piece, and then the details on second layer. Go ahead and tell me if I'm going about it wrong. I'm open to any suggestions. I'm also willing to pay for your time. It's worth it for me because I don't have time, because it takes me so long, and your time is worth something.

The PDF file is the correct version.
The SVG file imports incorrectly for me

Cabin Logo Final.pdf

Cabin Logo Final.pdf

Cabin Logo Final [Recovered].svg

Thank you everyone for your past help. Hopefully one of you experts can help me out with this.

Thanks again, Brandon

[Joe Jones]

My first question ... What will be the final width of this logo?
Joe


.

[Joe Jones]

Here is the logo with the closest stencil font

Joe

WITTS LOGO DXF.dxf

JJ-LOGO JPG.jpg

JJ-LOGO FULL SET JPG.jpg

[adbuch]

Here is the logo with the closest stencil font

Joe


WITTS LOGO DXF.dxf

JJ-LOGO JPG.jpg

JJ-LOGO FULL SET JPG.jpg

[weldguy]

NICE JOE! Great logo design for a cabin sign also!

[Joe Jones]

Thanks, but I did not design it. I just converted his PDF to a DXF file for cutting.

Joe



.

[Witt32]

Wow, thank you Joe! Sorry I didn't get back to you sooner. They'd like the sign to be 24" wide x whatever the height turns out to be. I'll try to get to it tonight if I have time. I may need to get back to you with some questions if you don't mind. I'd also like to pay you for your time.

Thanks!
Brandon

[Joe Jones]

I'd also like to pay you for your time.

Thanks!
Brandon

Send me a bag of M&Ms

PO Box 266
Franklin, KY 42134

Call anytime.

Joe



.