Hypertherm power max 65 question

[Long901]

So my plasma will fire and cut then on the next cut it won’t fire then on the next cut it will fire and cut,

So every other cut it works. I have a 30-0 code when it doesn’t fire, I’ve changed consumables, checked the torch, everything looks fine. Any suggestions???
This is on a table and not a hand torch.

[acourtjester]

This has been talked about here before, try looking with the search function in the upper right.
It is a stuck consumables error.
viewtopic.php?f=60&t=33154

[HypHyDef]

So my plasma will fire and cut then on the next cut it won’t fire then on the next cut it will fire and cut,

So every other cut it works. I have a 30-0 code when it doesn’t fire, I’ve changed consumables, checked the torch, everything looks fine. Any suggestions???
This is on a table and not a hand torch.

Hello Long901,
if you are not able to solve the issue using the link provided by acourtjester, please feel free to contact our technical service team here at Hypertherm. You can reach them a few ways. You can call them: Technical service -(800) 643-9878 or you can use the link and leave them an email.
https://www.hypertherm.com/en-US/contac ... -questions