I am considering extending the rails on my Pcam, DHC2. How do we tell the software that the table is not a 4x4 anymore? The "Advanced" tab under Machine / System Setup / Machine size is blanked out. I can not access it.
I know there are quite a few mods like this out there, how have you done it?
table extension software changes
-
cutterguy
- 2 Star Member
- Posts: 64
- Joined: Sat Mar 13, 2010 2:18 pm
-
Possumplasma
- 2 Star Member
- Posts: 54
- Joined: Tue Nov 23, 2010 5:56 pm
- Location: Murwillumbah, Australia
Re: table extension software changes
It depends on what version software you're running.
If it's 3.11 or earlier, it's quite easy.
Go to System setup, unclick table size, then click advanced....you can then set the table size to your hearts content.
However, if you're running the new Design Edge software, you'll have to part with another $998.00 for the priviledge.
Mick.
Aussie
If it's 3.11 or earlier, it's quite easy.
Go to System setup, unclick table size, then click advanced....you can then set the table size to your hearts content.
However, if you're running the new Design Edge software, you'll have to part with another $998.00 for the priviledge.
Mick.
Aussie
-
geo4932
- 2 Star Member
- Posts: 96
- Joined: Mon Jan 25, 2010 9:22 am
Re: table extension software changes
You will need the Customizable Table Size option from Plasmacam.
George
George
