MyPlasm CNC File Load Error

[Sk272010]

Hi Everyone, we use Autodesk Fusion 360 to design. We save sketches as dxf files. Sometimes this works however sometimes when we load into MyPlasm CNC we get a FILE LOAD ERROR and the image will not upload. Any ideas on what we are doing wrong saving in Autodesk or uploading to MyPlasm? Thanks in advance!

[East German]

Try another export version or upload the DXF here then you can have a look at it !!?

Peter

[bhamer62]

Save as an older version DXF, like 2004 If you can't save back that far, someone on here will do it for you. The software you are drawing with is simply a newer version than the one trying to read it....it has attributes that the older software has no clue what to do with so it boots it out.... Ya dun fried it's brain!!!! Ya just gotta dumb it down a bit....

[weldguy]

Ya dun fried it's brain!!!! Ya just gotta dumb it down a bit....

Thats funny. These guys are right I am sure, just try to save as older version and that should do the trick.