0.8mm nozzle on IPT60 torch ?

[WrineX]

Hi

I have a Primeweld CUt60S and it uses a PT60 torch, and i wondered if i can use any PT60 consumables ? since the primweld ones are 1.2mm witch is a bit to large for the small things i do. i seen some 0.8mm, and if you know of any smaller then that i would love to hear.

Like these
https://nl.aliexpress.com/item/32725649 ... 4c4d4VMZvB

i wondered if that should work ? and another question would my cutspeed go up or down ? i assume Up witch might be a problem but first i want to know if i am not destroying something

[adbuch]

I see no reason not to try them, assuming they are designed for your torch. I have attached the Hypertyerm cut charts below for comparison.
The recommended cut speeds for the FineCut consumables are definitely slower than those for the equivalent material thickness using the non-FineCut consumables. So I would say to slow down your cut speed for the smaller nozzles. You will need to experiment to find the optimum settings for your particular plasma cutter/table.

David

non-FineCut - mild steel.jpg

FineCut mild steel.jpg

[WrineX]

thank you i was looking to compare those but you found them before me thats nice, it would be beneficial to me to slow down so that would be great thanks ill let everyone know how it worked when i received them.

[adbuch]

Let us know how they work out for you. There may be others using the same machine who might benefit from your findings. Thanks!
David

[WrineX]

Let us know how they work out for you. There may be others using the same machine who might benefit from your findings. Thanks!
David

i will do for sure ! testing will commence when i got some time to set everything up again its messy.

but i will leave my experience here when i did !