Program to open tool files?

[Deezl Smoke]

Using Hypertherm 105 with mechanical torch on my Arclight table. I would like to know how to open tool files so that I can compare settings between a 30' torch and a 50' torch.
Does a simple stand-alone program or app exist somewhere that might accommodate this?

Thanks.

[acourtjester]

There is a free program called Notepad++ which will open many file types. Attached is my tools file from SheetCam and what it looks like.

[Deezl Smoke]

Thank you. I did open the file in a program like notepad, but was hoping to find a program that opens it in similar appearance to sheetcam in sae or inches measure. I probably should just save my edited tools and then reload the 50' toolset and see if that helps.

[djreiswig]

If the layout of the files is the same, i.e. same tools just different settings, you can open them both in winmerge and it will highlight the differences.
https://winmerge.org/

[Deezl Smoke]

Interesting. I;ll give that a try. Thank you.

[adbuch]

If the layout of the files is the same, i.e. same tools just different settings, you can open them both in winmerge and it will highlight the differences.
https://winmerge.org/

Thanks for sharing that. It looks like a very useful program which I will make note of for future reference.
David