Downdraft fan size question

[IUCTX]

I am trying to find the best type and size fan to exhaust the smoke/fumes/dust from my table. The table is 6x12 and has a v-shaped basin. Suspended halfway between the basin bottom and the cutting surface is a 7" ID steel pipe with 8ea 4" square 'ports'. There is only one outlet on the table located on one end. The table will be situated in my shop in such a way that the outlet of this pipe is 8' from the exterior wall, at 90 degrees from where I need to vent.

I have read good things about backward incline blowers. Any input on what size and type fan as well as connection methods will be much appreciated.

Thanks

IMG_20200923_155452.jpg

IMG_20200923_155445.jpg

IMG_20200923_155443.jpg

PXL_20200930_120753893.jpg

IMG_20200923_155507.jpg

EDIT: typo

[cuttinparts]

Man I don't have any suggestion on a fan for you but holy crap man that is a sick build! So well thought out and executed. Well done

[IUCTX]

So well thought out and executed.

Except for the exhaust fan part!

[cuttinparts]

Lol, ya I suppose. Oh well when you find the right fan for the job this is going to be sick!

[rcummings54]

Just curious IUCTX, were you able to find a fan that worked for your downdraft setup?

[IUCTX]

Just curious IUCTX, were you able to find a fan that worked for your downdraft setup?

Yes, I ended up going with this high pressure blower with a 5HP motor.