AXBB-E and MiniTHC

[Mr.Hotwire]

Im nearing the END of my build, I am utilizing an AXBB-E and a MiniTHC. In the MiniTHC manual it says to interface directly with the AXBB-E. I imagine I will need the port 3 BOB to plug the LPT port into or at least for the break out.

Any suggestions and guidance on this would be GREATLY appreciated.

[robertspark]

this is in the wrong section CandCNC

useport 3

get an idc 26pin ribbon cable to db25 (I cannot remember if it needs to be an M / F db25.... check!)

then setup the ports and pins as the minithc manual

[Mr.Hotwire]

OOF! Sorry... My bad.