Torch raises during cut and pushes rip into the material THC pricecnc

Don't see your table manufacturer listed above? Post here in this forum.
Chuckweb
2 Star Member
2 Star Member
Posts: 53
Joined: Mon May 03, 2021 3:31 pm

Re: Torch raises during cut and pushes rip into the material THC pricecnc

Post by Chuckweb »

Yes it has its own power supply
User avatar
Blackslacks
2 Star Member
2 Star Member
Posts: 87
Joined: Mon Apr 16, 2018 10:16 pm

Re: Torch raises during cut and pushes rip into the material THC pricecnc

Post by Blackslacks »

Another thing to check is make sure when wiring the thc that you are using the correct black wire that pairs with the various coloured wires. If they all become untwisted its impossible to tell which is which. You'll have to peel back the jacket to tell. Each black wire goes with a specific colour.
Chuckweb
2 Star Member
2 Star Member
Posts: 53
Joined: Mon May 03, 2021 3:31 pm

Re: Torch raises during cut and pushes rip into the material THC pricecnc

Post by Chuckweb »

sorry, for the late reply.

Yea i double checked checked the wires. I ended up unhooking it. I believe its the controller its self because when its turned off I can cut anything with no problems. I even had pricecnc help me go over everything and their clueless now lol. im going to get a different THC later on and go from there.

thank you
Post Reply

Return to “Various Manufacturers Forum”