Need .PCM converted to DXF

goodhue1 · Post by **goodhue1** » Fri Apr 17, 2020 4:53 pm

I have a Plasmacam file I need converted to DXF. I have old Plasmacam software and need to get this sent out. Thanks for the help!

Post by **knight7338** » Fri Apr 17, 2020 9:03 pm

here it is converted. there were several intersections and unjoined lines that i corrected

Post by **knight7338** » Fri Apr 17, 2020 9:05 pm

sorry file was to big i will have to figure out how to compress it and reattach

Post by **knight7338** » Fri Apr 17, 2020 9:10 pm

lets try this again

goodhue1 · Post by **goodhue1** » Sat Apr 18, 2020 12:41 am

Thank you so much! I really appreciate it!

Post by **Joe Jones** » Mon May 17, 2021 10:00 am

Well, that is a converted file, but it is rough. No symmetry. Perhaps that is what you were after. I guess it would work okay, but it could sure use some attention to detail. Have you already cut it? How did it come out? Post a photo for all of us Covid captives!

Joe

Post by **adbuch** » Mon May 17, 2021 4:29 pm

goodhue1 wrote: ↑Fri Apr 17, 2020 4:53 pm I have a Plasmacam file I need converted to DXF. I have old Plasmacam software and need to get this sent out. Thanks for the help!

Here is it converted and smoothed to reduce node count. Nice file!
David

Window Cross image.jpg

Window Cross rev. 1.dxf

Need .PCM converted to DXF

Need .PCM converted to DXF

Re: Need .PCM converted to DXF

Re: Need .PCM converted to DXF

Re: Need .PCM converted to DXF

Re: Need .PCM converted to DXF

Re: Need .PCM converted to DXF

Re: Need .PCM converted to DXF