EASYSCRIBER QUESTIONS

[EasyScriber]

BTW, this will be used on a PlasmaCam DHC2, with the 3.11 software. Anything in particular to be aware of?

Nothing else, your good to go.

Just visit this link to see the settings for EasyScribing with PlasmaCam viewtopic.php?f=172&t=28846

Let us know if you have any additional questions

[JohnnyC]

I need settings for wincnc can anyone help?

[EasyScriber]

I need settings for wincnc can anyone help?

Have not had the opportunity to run one using WinCNC. What problems are you seeing?

[JohnnyC]

I talked to my table rep and he got it working. You may want to get a copy of WinCNC so you can give instructions

[EasyScriber]

I talked to my table rep and he got it working. You may want to get a copy of WinCNC so you can give instructions

That was our first move since there is a demo of WinCNC available however without the hardware on the other end to actually test we could not confirm anything. Very interested in what you learned and how its working for you.

[JohnnyC]

Have to go into WinCNC every time and change all instances of 2 lines of code. It works alright so far

[BLUFLAME-FABRICATION]

Weldguy How did you cut it out after engraving? Cut first then engrave?

[weldguy]

Because this needed to have the markings in the paint this piece had to be cut and finished before scribing.