Hello,
Is anyone out there using RhinoCAM for their plasma table? I am getting comfortable with Rhino3D and need a post processor. Will it do kerf compensation? Has anyone used RhinoCAM for this successfully?
Thanks in advance for any help you can give
RhinoCAM on a plasma table
-
EverydayDiesel
- 2 Star Member
- Posts: 74
- Joined: Sun May 31, 2020 11:46 am
-
acourtjester
- 6 Star Elite Contributing Member
- Posts: 8183
- Joined: Sat Jun 02, 2012 6:04 pm
- Location: Pensacola, Fla
Re: RhinoCAM on a plasma table
Les from SheetCam has helped other in the past, if you find one of his posts then look to the right and under his name click on the icon. This will bring up another small icon click on that to send him a private message from here.
- les.JPG (19.59 KiB) Viewed 445 times
- les.JPG (19.59 KiB) Viewed 445 times
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
-
EverydayDiesel
- 2 Star Member
- Posts: 74
- Joined: Sun May 31, 2020 11:46 am
Re: RhinoCAM on a plasma table
Is sheetcam related to rhinocam?
