CommandCNC, torch stops
-
Foley
- 1/2 Star Member
- Posts: 1
- Joined: Sat May 16, 2020 11:35 am
CommandCNC, torch stops
I can run a program with the torch off and it will run the whole thing. If I try to run the program with the torch on, it will stop partway though the job. I've tried 3 different programs, one of which I know worked when I picked up the table. When running a program repeatedly, it will stop at the same place every time. Ideas?
-
weldguy
- 4.5 Star Elite Contributing Member
- Posts: 2314
- Joined: Fri Apr 17, 2009 11:48 am
Re: CommandCNC, torch stops
Post your gcode and I am sure someone here will be able to help 
